Transitions 3 Chapter

•When you press the [AUTO TRANS] button, until the state of the next transition, the transition is carried out over the duration given by the transition rate.

•When you move the fader lever, the transition is carried out from the pattern limit state to the state before the pattern limit transition was carried out.

However, moving the fader lever even a little synchronizes the fader lever position with the transition state, and you can move the fader lever either in the forward direction or in the reverse direction.

Depending on the Setup settings, the transition may be executed at the instant you press the [PTN LIMIT] button, and the button goes off. In this case, execution continues for the time specified by the dedicated transition rate in the menu setting, as far as the state of the next transition.

For details of the setting, see “Settings Relating to Keys, Wipes and Frame Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).

To set the transition rate when the pattern limit is released Use the following procedure.

1 In the <Pattern Limit Release> group of the Edge/Direction menu, select one of the following.

Auto Trans Rate: Use the transition rate set in the transition rate control block

Independ Trans Rate: Independent transition rate

2 If you selected “Independ Trans Rate” in step 1, adjust the following parameter.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Transition Rate

Independent transition rate

0 to 999 (frames)

 

 

 

 

242 Executing a Transition