Functions 9000-DVS 1 Chapter

You can make the following settings.

Settings relating to overall switcher configuration (Config)

•System Phase: Adjust the switcher internal reference phase.

•Switch Timing: Specify the timing of video switching.

•M/E Config: Set the program configuration for the M/E and P/P outputs.

–Standard mode: Fix the maximum of four outputs (Out1 to 4) and program output configuration as follows.

Out1: Program output

Out2: Preview output

Out3: Clean output

Out4: Key preview output

Program output: Clean output + key 1 + key 2 + key 3 + key 4

–Multi-program mode: Increase the number of M/E or P/P programs, and assign any of the following to the maximum of six outputs (Out1 to 6).

Program outputs 1 to 4, preview output, key preview outputs 1 and 2, clean output.

Further, you can select the program background from Clean or Utility2, and change the combination of signals from which it is configured. Again, you can set the key preview configuration to video mode or key mode. In key mode, select whether to link operation to the on/off state of the key, or have it always on.

–DSK mode: Treat P/P as four DSKs, with no background transitions. Of backgrounds 1 to 4, set one to configure the program output. The signals which can be selected as the background are limited to Out1 to 6 from M/E-1 to M/E-3.

•K-PVW Config: Set the key preview configuration to either video mode or key mode. In key mode, select whether to link the key state to the on/off operation, or have it always on.

•User 1 to 8 Config: Assign the User regions, being color backgrounds 1 and 2, AUX1 to 48, monitor 1 to 8, and frame memory 1 to 8, to any of USER1 to USER8.

•Logical M/E Assign: Make settings for handling PGM/PST hardware logically as an M/E.

Input signal settings (Input)

•Input Phase Adjust: Carry out phase adjustment for each primary input.

•Through Mode: Set through mode for the input side. This applies only to the primary inputs, and can be set independently for each primary input.

•Video Process: Switch video processing on or off for each input signal, and adjust the brightness, hue and so forth.

•Matte Illeg. Color Limit: Switch the illegal limiter on or off for the signal generated by the switcher internal matte generator.

152 Setup