Wipes DME 6 Chapter

Specifying the DME wipe direction (Direction)

You can specify the DME wipe direction (normal/reverse).

To specify the DME wipe direction in a menu

Use the following procedure.

1 In the M/E-1>DME Wipe menu, select HF4 ‘Edge/Direction.’

The Edge/Direction menu appears.

2 In the <Direction>group, specify the DME wipe direction.

Normal: regular direction

Normal/Reverse: alternate between regular and reverse for each transition

Reverse: reverse direction to normal

To specify the DME wipe direction with a button in the transition control block

In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST banks, press the following direction selection buttons.

NORM: Normal

NORM/REV: Normal/reverse

REV: Reverse

Modifying the DME wipe pattern edge

Use the following procedure.

1 In the M/E-1>DME Wipe menu, select HF4 ‘Edge/Direction.’

The Edge/Direction menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.

3 In the <Edge> group, select the edge type.

Border: border

Soft Border: soft border

334 Basic Procedure for DME Wipe Settings