Keys 4 Chapter

•When turning [Speed] on in the <Rotation> group and setting the rate of pattern rotation

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Speed

Rate of pattern rotation

−100.00 to +100.00 a)

a) See page 62.

Using the subsidiary mask

For example, to use the subsidiary mask for key 1 on the M/E-1 bank, use the following procedure.

1 In the M/E-1>Key1 menu, select HF4 ‘Sub Mask.’

The Sub Mask menu appears.

2 In the <Mask Type> group, select the mask type.

Key Mask: Masks a part of a key.

Bkgd Mask: Masks a part of a background.

3 In the <Mask Source> group, select the mask source.

Wipe: wipe pattern selected for a transition

If you select [Wipe], select the pattern and make modifier settings in the M/E-1>Wipe menu (see page 304), then return to this M/E- 1>Key1 menu.

In the case of a wipe pattern selected for a mask, the modifier [Edge] and [Direction] settings are not available.

Utility 1 Bus: signal selected on the utility 1 bus

When you selected [Utility 1 Bus], hold down the [UTIL] button in the M/E-1 bank cross-point control block, and select the signal with the background A bus buttons. While the [UTIL] button is pressed, the background A bus switches to the utility 1 bus.

Note

To enable the [UTIL] button, its operation mode must be set to [Hold] beforehand. (See “Operation Settings (Operation Menu)” in Chapter 16 (Volume 2).)

4 Set the mask source parameters.

• When wipe is selected

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Size

Pattern size

0.00 to 100.00

 

 

 

 

282 Key Setting Operations Using Menus