Main and sub modifier link function
When carrying out a pattern mix, it is possible to link the modifier settings for the main pattern and sub pattern. There are two modes for this function.
FULL LINK (fully linked) mode
In this mode, all modifier settings are the same for the main pattern and sub pattern.
Changing the modifier settings for one pattern automatically changes the settings for the other.
SEMI LINK
Only the parameter settings of the modifiers are linked. The modifier on/off settings are not linked. When the parameter values for the modifiers of the main pattern and sub pattern are different, then after this link mode is selected, changing the value of a parameter for one pattern changes the value of the parameter for the other pattern to maintain the same difference between the two.
Note
When carrying out a wipe transition using a pattern mix, it is recommended that you set the modifier link function to “FULL LINK” mode.
If the link function is off, or SEMI LINK mode is selected, the desired effect may not be obtained at the start or end of the transition.
Wipe Pattern Variation and Modifiers
You can carry out a wipe with the following variations and modifications to the selected pattern. (For details, see “Setting Wipe Modifiers” (page 309).)
Direction
You can specify the direction of the wipe: the regular direction is referred to as “normal”, and the other direction as “reverse.” You can also select alternating directions each time the transition is completed (normal/reverse mode).
Functions
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Normal |
| Reverse | |||||
|
|
|
|
|
|
|
|
|
Wipes 59