2 Set the following parameters.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Position H | Horizontal position | −200.00 to +200.00 a) |
2 | Position V | Vertical position | −200.00 to +200.00 a) |
a) See page 61.
To move the pattern from its current position to the center through the course of a transition
Press [Auto Center] in the <Position> group, turning it on.
Rotating the wipe pattern (Rotation)
Use the following procedure.
1 In the <Rotation> group of the Key1 Wipe Adjust menu, select the rotation type.
Angle: Incline the pattern through a fixed angle.
Speed: Rotate at a speed rate.
Magnitude: Rotate the pattern through a fixed angle during the course of the transition.
2 According to the selection in step 1, set the following parameters.
• When Angle is selected
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Angle | Angle of pattern rotation | −100.00 to +100.00 a) |
a) See page 61.
• When Speed is selected
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Speed | Rotation rate of pattern | −100.00 to +100.00 a) |
a) See page 62.
Wipes 5 Chapter
Wipe Settings for Independent Key Transitions | 325 |
|
|