1 In the auxiliary bus control block, press the AUX delegation button to which frame memory source bus 1 is allocated, turning it on.
For allocation of buses to the AUX delegation buttons, see “AUX Delegation Buttons Settings (Aux Assign Menu)” in Chapter 16 (Volume 2).
2 In the auxiliary bus control block
To select a signal with a key or DME effect applied on the frame memory source bus
In the key control block, press the [FM FEED] button, turning it on.
This automatically assigns the key fill and key source signals being keyed by the currently selected keyer to frame memory source buses 1 and 2.
When DME is selected on the keyer, the key fill and key source signals to which a DME effect is applied are assigned.
Selecting Outputs and Target Frame Memory
Selecting outputs (FM) and target frame memory
The signals of frame memory source buses 1 and 2 are used assigned to one of the pairs of FM1&2, FM3& 4, FM5&6, and FM7&8. The following description applies to the case of assignment to FM1&2, but the procedures are similar for the other cases.
1 In the Frame Memory menu, press one of VF1 to VF3, and select the required HF menu.
The current status of frame memory appears in the status area. (See page 349.)
2 If required, press [Pair], to select the FM operation mode (pair mode).
On: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) as a pair.
Off: Operate on FM1(3, 5, 7) and FM2(4, 6, 8) individually.
For more details, see “Pair mode” (page 73).
3 In the <Select> group, press [FM1 & FM2] to select it.
This assigns the signals to FM1 and FM2.
To the right of the target FM selection buttons (see page 349), the FM output status appears.
Memory Frame 7 Chapter
Frame Memory Operations 351