Wipes 5 Chapter
• | When soft edge is selected |
| ||
|
|
|
| |
Knob | Parameter | Adjustment | Setting values | |
|
|
|
|
|
1 |
| Soft | Edge softness | 0.00 to 100.00 |
|
|
|
|
|
• | When soft border is selected |
| ||
|
|
|
| |
Knob | Parameter | Adjustment | Setting values | |
|
|
|
|
|
1 |
| Width | Border width | 0.00 to 100.00 |
|
|
|
|
|
2 |
| Inner Soft | Border inner softness | 0.00 to 100.00 |
|
|
|
|
|
3 |
| Outer Soft | Border outer softness | 0.00 to 100.00 |
|
|
|
|
|
4 When you selected border or soft border, select the edge fill signal in the <Edge Fill> group.
Utility 2 Bus: signal selected on the utility 2 bus
Matte: signal from the dedicated color matte generator
5 Depending on the operation in step 4, carry out the following operation.
When ‘Utility 2 Bus’ is selected: Hold down the [UTIL] button in the
While the [UTIL] button is held down, the background B bus changes to the utility 2 bus.
Note
To enable the [UTIL] button, its operation mode must be set to [Hold] beforehand. (See “Operation Settings (Operation Menu)” in Chapter 16 (Volume 2).)
When ‘Matte’ is selected: In the same Edge/Direction menu, press [Matte Adjust] to display the Matte Adjust menu, then adjust the
Flat Color: Adjust color 1 with the following parameters.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Luminance | Luminance | 0.00 to 100.00 |
|
|
|
|
2 | Saturation | Saturation | 0.00 to 100.00 |
|
|
|
|
3 | Hue | Hue | 359.99 to 0.00 |
|
|
|
|
When you select Mix Color for a
312 Basic Procedure for Wipe Settings