Setting the DME wipe pattern size (Size)

Use the following procedure.

1 In the M/E-1>DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.

3 Press [Size], turning it on.

4 Set the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Size

Set size of effect

0.00 to 200.00 a)

a) The current effect size of the DME wipe pattern is taken as 100.00%.

Display indications when multiple channels are selected at the same time

The indications on the knobs show the settings of the lowest-numbered channel. When you turn the knobs to adjust the settings, this changes the settings on the other channels by the same amount.

Adjusting the DME wipe pattern cropping

Use the following procedure.

1 In the M/E-1>DME Wipe menu, select HF5 ‘Modify.’

The Modify menu appears.

2 Depending on whether the selected pattern is in one-channel mode or two- channel mode, proceed as follows.

For a pattern in one-channel mode: press [1st Ch], turning it on.

For a pattern in two-channel mode: from the <Ch Select> group, select the corresponding channel. You can select more than one channel at the same time.

Wipes DME 6 Chapter

Basic Procedure for DME Wipe Settings 337