When emboss is selected:

Knob

Parameter

Adjustment

Setting values

 

 

 

 

 

1

Width

Width

0.00 to

4.00

 

 

 

 

2

Position

Position

359.99 to 0.00

 

 

 

 

 

3

Density a)

Density

0.00 to

100.00

a)The Density adjustment only affects the key edge. This can be adjusted separately from Key Density, and if Key Density is set to 0.00, the embossed edge effect only can be applied.

To make edge fill adjustments, carry out the settings in step 6.

4 Select the edge fill signal in the <Edge Fill> group.

Utility 1 Bus: signal selected on the utility 1 bus

Matte: signal from dedicated color matte generator.

It becomes possible to adjust color 1.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Luminance

Luminance

0.00 to 100.00

 

 

 

 

2

Saturation

Saturation

0.00 to 100.00

 

 

 

 

3

Hue

Hue

359.99 to 0.00

 

 

 

 

When the edge type is outline, in place of the edge fill signal, the selected key fill signal fills the outline, and elsewhere remains as the background.

5 Carry out the following operation, depending on the selection in step 4.

When [Utility 1 Bus] is selected: Hold down the [UTIL] button in the cross-point control block, and select the signal in the background A bus row.

While the [UTIL] button is held down, the background A bus changes to the utility 1 bus.

Note

To enable the [UTIL] button, its operation mode must be set to [Hold] beforehand. (See “Operation Settings (Operation Menu)” in Chapter 16 (Volume 2).)

When [Matte] is selected: Press [Matte Adjust] in the same EDGE menu, to display the Matte Adjust menu, and adjust a single color or two- color combination color matte.

You can select whether to use a single color matte or a two-color combination color matte in the <Edge Matte> group.

Keys 4 Chapter

Key Setting Operations Using Menus 275