Key Snapshot Operations Using a Simple Transition Module
When using a simple transition module, the key snapshots hold the settings for key 3 and key 4.
You can carry out key snapshot operations in the independent key transition control block (simple type) and Flexi Pad control block (simple type). There are two dedicated key snapshot registers for each of keys 3 and 4.
| Key 3 control block | Key 4 control block | ||||
Key source name display/key |
|
|
|
|
|
|
snapshot buttons |
|
|
|
|
|
|
WIPE | DME | WIPE | DME | |||
| SHIFT | MIX | CUT | SHIFT | MIX | CUT |
|
| KEY3 |
|
| KEY4 |
|
|
| ON |
|
| ON |
|
|
| TAKE |
|
| TAKE |
|
The functions of the key 3 control block and key 4 control block are the same.
Independent key transition control block (simple type)
Saving a key snapshot
For example, to save the settings of
1 In the
This switches to key snapshot mode, and the key source name display/key snapshot button shows the state of registers 1 and 2 for key 3.
Off: Nothing is saved in the register.
Lit orange: Settings are saved in the register.
Lit yellow: The most recently recalled register.
For a register holding a snapshot, the register name is shown as up to eight characters.
Keys 4 Chapter
Key Snapshots 301