Functions 9000-DVS 1 Chapter

•Xpt Hold mode: Set the operation mode for the cross-point hold button provided on the key bus for each of the M/E and P/P banks.

•Pattern Limit Transition: Set the operation mode when the pattern limit is released for each of the M/E and P/P banks.

•Wipe Edge Default: Adjust the wipe edge softness for each of the M/E and P/P banks.

•FM Auto Store: Switch on or off the function to automatically attach a name and save in frame memory.

Link settings (Link)

•Internal Bus Link: Make a setting of the bus link function that links together two buses internal to the switcher.

•GPI Link: Make settings for linking any cross-point buttons or [CUT] and [AUTO TRANS] buttons in the cross-point control block and GPI output ports.

External device connections (Device Interface)

•Remote Assign: Set the use of the four 9-pin ports.

•GPI Input: Set the GPI input ports and trigger polarities, and make the action settings.

•GPI Output: Set the GPI output ports and trigger polarities, and make the action settings.

•Aux Control: Set whether operations on the Aux buses from the four 9-pin ports are inhibited.

DME Setup

In DME setup, carry out settings particular to the DME processor.

You can make the following settings.

Input signal settings (Input)

•Initial Crop: Make the initial crop setting.

•Matte Illeg. Color Limit: Switch the illegal limiter for the signal generated by the DME internal matte generator on or off.

Interface with external devices (Device Interface)

•Editor Protocol: Set the protocol to be used on the Editor port.

•Editor Port Setting: Make settings relating to the control of the four editor ports installed in the DME.

•GPI Input: Set the GPI input ports and trigger polarities, and make the action settings.

154 Setup