Banks and Registers
In a standard type Flexi Pad control block, in order to handle the 99 registers, they are considered in groups. These groups are called “banks,” and there are ten banks, numbered from 0 to 9.
The correspondence between banks and registers is shown in the following table.
Bank number | Register numbers |
|
|
Bank 0 | 1 to 10 |
|
|
Bank 1 | 11 to 20 |
|
|
Bank 2 | 21 to 30 |
|
|
Bank 3 | 31 to 40 |
|
|
Bank 4 | 41 to 50 |
|
|
Bank 5 | 51 to 60 |
|
|
Bank 6 | 61 to 70 |
|
|
Bank 7 | 71 to 80 |
|
|
Bank 8 | 81 to 90 |
|
|
Bank 9 | 91 to 99 |
|
|
Example: When you select bank 3, the register numbers allocated to the memory recall section are as follows.
37 38 39
34 35 36
31 32 33
40
Operations with a simple type Flexi Pad control block
With a simple type Flexi Pad control block, the registers that can be handled are numbers 1 to 8. Bank operations are therefore not possible. It is also not possible to apply attributes, or to cancel a snapshot save or recall operation once carried out.
To use registers 9 to 99, or to cancel a snapshot save operation, use the numeric keypad control block.
Snapshots 14 Chapter
Snapshot Operations in the Flexi Pad Control Block 165