2 Press [Yes].

This saves the setup settings for the selected devices in non-volatile memory within the respective devices.

To save the Initial Status settings

Use the following procedure.

1 After selecting the devices the settings apply to, in the System>Start Up menu, press [Init Status Define].

A confirmation message appears.

2 Press [Yes].

This saves the initial status settings other than the “setup” settings for the selected devices in non-volatile memory within the respective devices. For the control panel, only the key bus delegation buttons are saved.

Reset and Initialization (Initialize Menu)

To carry out a reset or memory initialization for a device, use the

System>Initialize menu.

To display the Initialize menu

In the Engineering Setup menu, select VF1 ‘System’ and HF5 ‘Initialize.’ The status area shows the current start-up mode settings.

Resetting the device and initializing memory

Use the following procedure.

1 In the status area of the System>Initialize menu, select the device to which the settings are to apply.

2 In the <Initialize> group, select one of the following modes.

Reset: Reset the device.

All Clear: Initialize memory.

3 Press [Execute].

A confirmation message appears.

Setup Engineering 16 Chapter

Setup for the Whole System 201