Setup for the Whole System
Carry out operations relating to setup in the Engineering Setup menu.
To access the Engineering Setup menu, press the top menu selection button [ENG SETUP].
For an overview of setup, see “Setup” in Chapter 1 (Volume 1).
Setting the unit ID
When there are two switchers and connected DME units on the same network, it is necessary to set the unit ID on each device, as follows.
Device | ID |
|
|
|
|
|
|
1st switcher | 1 |
|
|
|
|
|
|
2nd switcher | 2 |
|
|
|
|
|
|
|
|
|
|
Device |
|
| ID |
|
| ||
DME for 1st switcher (channels 1 to 4) | 1 | ||
|
| ||
DME for 2nd switcher (channels 1 to 4) | 3 | ||
|
|
|
|
For more details of how to make the device ID settings, refer to the installation manual for the particular device.
Network Settings (Network Config Menu)
To display the Network Config menu
In the Engineering Setup menu, select VF1 ‘System’ and HF1 ‘Network Config.’
The status area shows the device ID, and Control LAN and Data LAN IP addresses for each device excluding the DCU.
Making the network settings
Use the following procedure.
1 In the System>Network Config menu, press [Auto Config].
This automatically checks all devices (excluding the DCU) connected to the Data LAN.
Setup Engineering 16 Chapter
Setup for the Whole System 195