Snapshots 14 Chapter

Saving and Recalling Snapshots

Saving a snapshot with the Flexi Pad control block

As an example, to save a snapshot on the M/E-1 bank, use the following procedure.

1 In the M/E-1 bank, make the settings for the state you want to save as a snapshot.

2 In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.

This allocates the Flexi Pad control block to snapshot operations. The numeric display shows the last selected bank number and the register number last recalled on the bank.

3 Use any of the following methods to select the bank for saving the snapshot.

(On a simple type Flexi Pad control block, there are no banks, and this operation is not necessary.)

To select bank 0: Press the [BANK 0] button.

To select bank 1: Press the [BANK 1] button.

To select any bank from 0 to 9: Press the [BANK SEL] button, changing the memory recall section display as shown below; select a number from 0 to 9.

7 8 9

4 5 6

1 2 3

0

The selected bank number appears in the numeric display.

The buttons in the memory recall section change to show the names of the registers in the selected bank, together with the register status.

Using the Setup menu, it is possible to specify which to display, the register name or register number.

Lit orange: Register containing a snapshot

Lit yellow: Last recalled register

166 Snapshot Operations in the Flexi Pad Control Block