Snapshots 14 Chapter

1 In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button.

This allocates the Flexi Pad control block to snapshot operations. The numeric display shows the last selected bank number and the register number last recalled on the bank.

2 Select the bank for recall.

See step 3 (page 166) in “Saving a snapshot with the Flexi Pad control block.”

3 To apply temporary attributes, press the following buttons, turning them on.

Control block

Temporary

Button

 

attribute to apply

 

 

 

 

Cross-point control

A/B bus cross-point

[XPT HOLD] button in the

block

hold

background A/B bus

 

 

 

 

Key cross-point hold

[XPT HOLD] button in the key bus a)

 

Key disable

[XPT HOLD] button in the key bus b)

Flexi Pad control

Effect dissolve

[EFF DISS] button

block

 

 

Auto transition

[AUTO TRANS] button

 

 

 

 

a)When Xpt Hold mode is selected in setup.

b)When Key Disable mode is selected in setup.

For details of temporary attributes and available attributes, see “Snapshot Attributes” in Chapter 1 (Volume 1).

Notes

•The cross-point hold and key disable settings are maintained until you next press the [XPT HOLD] button.

•Applying temporary attributes does not affect the contents of the register.

4 Press the button in the memory recall section which shows the desired register name.

The button you pressed lights yellow, and this recalls the snapshot. The numeric display shows the selected register number after the bank number.

To cancel a snapshot recall operation

After recalling a snapshot, to cancel the recall, press the [UNDO] button.

168 Snapshot Operations in the Flexi Pad Control Block