Setup Engineering 16 Chapter
Setup Relating to Router Interface and Tally
Router Interface Settings (Router Menu)
In this system, the interface with a router (routing switcher) uses the
To carry out this assignment, use the Router/Tally>Router menu. The assignment is common to the parallel and serial tallies.
To display the Router menu
In the Engineering Setup menu, select VF6 ‘Router/Tally’ and HF1 ‘Router.’ The status area shows the device names to be assigned to the
Assigning switcher inputs and outputs to
Use the following procedure.
1 In the <Device> group of the Router/Tally>Router menu, select the device to which the settings apply.
SWR1: Settings apply to switcher 1.
SWR2: Settings apply to switcher 2.
Note
When there are two switchers on the same network, the SWR2 (second switcher) settings are required. If there is only one switcher, the settings are not required.
2 In the <Matrix Size> group, select the matrix size.
Standard (136 ⋅ 138): Assign the switcher
Compact (128 ⋅ 128): Assign the switcher
3 Turn the knobs to set the parameters for the following items.
Source: Specify the start address of the matrix source.
Destination: Specify the start address of the matrix destination.
278 Setup Relating to Router Interface and Tally