2 Make the following settings as required.
Operation mode of the [ALL] button in the transition control block: To specify the next transition to be selected by pressing the [ALL] button in the transition control block, press the next transition you want to select, turning it on, in the <Next Trans All> group. If everything here is set to OFF, then pressing the [ALL] button does not change the specification of the next transition.
Operation mode during an auto transition: For the operation mode when the [AUTO TRANS], [TAKE] or [FTB] button is pressed once more during an auto transition, select [Continue] or [Cancel] in the <Auto Trans/Take> group.
Continue: Continue the auto transition.
Cancel: Cancel the auto transition and return to the state before starting the auto transition.
Operation mode during keyframe execution: For the operation mode when the [RUN] button is pressed once more during effect execution, select [Continue] or [Cancel] in the <RUN> group.
Continue: Continue the execution.
Cancel: Cancel the execution and return to the state before starting the execution.
Interchanging the [AUTO TRANS] and [CUT] buttons: To interchange the [AUTO TRANS] and [CUT] buttons in the transition control block, press the [Auto Trans/Cut Swap] button, turning it on.
[UTIL] button operation mode: To set the operation mode of the [UTIL] button in the
Hold: Acts as a utility button while held down, changing the assignment of the
Lock: For the key rows, each time the button is pressed the
Transition preview operation mode: For the operation mode of the [TRANS PVW] button, select [Lock] or [Hold] in the <Trans Pvw> group. The setting as to whether to use the
Operation mode of the [XPT HOLD] buttons in the key rows: Set the operation mode of the [XPT HOLD] buttons in the key rows in the <Key Bus Xpt Hold> group, as follows.
Normal: The <Xpt Hold Mode> in the Switcher>Key/Wipe/FM menu is enabled.
Setup Engineering 16 Chapter
Setup Relating to Operations From the Control Panel | 231 |
|
|