Operations DME 11 Chapter
Note
When you turn on keyframe strobe, if the trail or motion decay effect is on, it automatically goes off.
Leaving a trail of afterimages of the image
Use the following procedure.
1 In the DME menu, select VF5 ‘Light/Trail’ and HF4 ‘KF Strobe.’
The KF Strobe menu appears.
2 Press [KF Strobe], turning it on.
This enables the keyframe strobe effect, and you can now use the knobs to adjust the parameters.
3 Set the following parameter.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Decay | Degree of blurring of the video | 0.00 to 100.00 a) |
|
| signal |
|
|
|
|
|
a)At the setting 0.00, there is no afterimage. At a setting of 100.00, the afterimage does not decay.
4 To erase the afterimage, press [KF Strobe Eraser], turning it on.
Selecting the overlay priority for movie and still images (video freeze image)
In the <Priority> group, select the way in which the images are overlaid.
Over: the movie is on top, and the still image is underneath.
Under: the movie is underneath, and the still image is on top.
Mix: the movie and still images are mixed; adjust the following parameter with the knob.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Mix | Mix amount of the still image with | 0.00 to 100.00 a) |
|
| respect to the movie |
|
|
|
|
|
a) The 0.00 setting is the same as Over, and the 100.00 is the same as Under.
Selecting the freeze timing
In the <KF Freeze Timing> group, select the timing for freezing the keyframe strobe.
72 DME Special Effect Operations