Auto: When the pattern limit is released, the remainder of the transition is carried out automatically at a
Manual: After the pattern limit is released, the transition waits for the next operation, then executes. Until you move the fader lever or press [AUTO TRANS], the transition is not executed.
Setting the default wipe edge softness
Use the following procedure.
In the Switcher>Key/Wipe/FM menu, adjust the following parameter to set the default value.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
3 | Wipe Edge | Default value of wipe edge softness | |
| Soft |
|
|
|
|
|
|
Settings Relating to Function Links (Link Menu)
Carry out setup relating to links by displaying the Switcher>Link menu.
To display the Link menu
In the Engineering Setup menu, select VF3 ‘Switcher’ and HF6 ‘Link.’ The status area shows the current link information.
Setting a
To link together two buses internal to the switcher, use the following procedure.
1 In the Switcher>Link menu, press [Internal Bus Link].
The Internal Bus Link menu appears.
The status area shows the link source and link destination buses, and link table information.
2 Using any of the following methods, select what setting applies to.
•Press directly on the list appearing in the status area.
•Press the arrow keys to scroll the reverse video cursor.
•Turn the knob to make the setting.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Link No | Link number | 1 to 64 |
|
|
|
|
Setup Engineering 16 Chapter
Setup Relating to Switcher Processor | 249 |
|
|