Setup Engineering 16 Chapter
2 Once switch to another menu, then display the Network Config menu again.
Now the status area of the System>Network Config menu shows the results of the automatic check.
Note
Be sure to carry out this operation after reconfiguring the system, or after a software upgrade.
System Settings (System Config Menu)
To make the system settings, use the System>System Config menu.
To display the System Config menu
In the Engineering Setup menu, select VF1 ‘System’ and HF2 ‘System Config.’
Note
After changing any of the following settings, be sure to press [Execute] to save the new values. If you want to cancel the setting changes without saving them, press [Clear].
Selecting the system operation mode
In the <Operation Mode> group of the System>System Config menu, select one of the following.
Single Proc: Control mode in which the panel controls a switcher and the DME connected to the switcher.
Dual Simul: Control mode in which the panel controls two switchers and the DME connected to each switcher simultaneously.
Specifying the switcher controlled by the control panel
Use the following procedure.
1 In the System>System Config menu, press the [Panel Assign] button.
The Panel Assign menu appears.
196 Setup for the Whole System