2 In the <Sub Table Select> group, select the sub table you want to set.

3 Using any of the following methods, select the cross-point button for which you want to make an assignment.

•

Press directly on the list in the status area.

 

•

Press the arrow keys to scroll the reverse video cursor.

 

•

Turn the knob to make the setting.

 

 

 

 

 

Knob

Parameter

Adjustment

Setting values

 

 

 

 

 

1

 

Sub Button No

Sub cross-point button selection

1 to 128

 

 

 

 

 

•

To disable operation of a button number, press [Inhibit].

4 Turn the knob to select the main cross-point button number to be assigned.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

3

Main Source No

Main cross-point button selection

1 to 128

 

 

 

 

To select a cross-point button number while checking which sources can be selected

In place of steps 3 and 4 in the above procedure, you can use the following procedure for the setting.

1 Press [Source Select].

The Source Select menu appears.

In the upper part of the status area, the selected Sub and Main button numbers and the currently assigned video and key signal names appear. In the lower part, a list of the assignable signals appears.

2 Referring to steps 3 and 4, select the signal to be assigned.

Setting the cross-point button shift operation

You can set the operation of the rightmost button in each row of cross-point buttons excluding the reentry buttons.

In the <Xpt Shift Mode> group of the Panel>Xpt Assign>Multi Xpt Assign menu, select one of the following for each cross-point table.

Hold: Acts as a shift button, and the shifted version of the cross-point buttons is enabled while the button is held down.

Lock: Acts as a shift button, and pressing the button toggles between the shifted version and the unshifted version.

Off: Acts as a cross-point button, in a 16-button system as button number 16, in a 24-button system as button number 24, and in a 32-button system as button number 32.

Setup Engineering 16 Chapter

Setup Relating to Operations From the Control Panel

215