Setup Engineering 16 Chapter
When Source is P/P: Cut, Auto Trans
DSK1 Cut, DSK1 Auto Trans, DSK2 Cut, DSK2 Auto Trans, DSK3 Cut, DSK3
Auto Trans, DSK4 Cut, DSK4 Auto Trans
FTB Cut, FTB Auto Trans
DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK4 SS ? Recal
Effect ? Recall, Effect ? Recall & Run, KF Run, KF Stop, KF Rewind, No Action
When Source is Common: No Action
•Action list when the trigger type is “Status”
When Source is
No Action
When Source is P/P: DSK1 On, DSK2 On, DSK3 On, DSK4 On
No Action
When Source is Common: Error Make, Error Break, No Action
b)When knob 2 selection is “Key Snapshot”
c)When knob 2 selection is “Snapshot” or “Effect”
7 Press [Action Set] to confirm the action selection.
The selected setting appears in the status area.
Test firing the trigger
To test fire the trigger, press [Test Fire].
This outputs a trigger from the selected output port. This is not output when the trigger type is “Status.”
Enabling or disabling Aux bus control
Use the following procedure.
1 In the Switcher>Device Interface menu, press [Aux Control].
The Aux Control menu appears.
2 Select the
Remote1: Make the settings for the REMOTE1 port.
Remote2: Make the settings for the REMOTE2 port.
Remote3: Make the settings for the REMOTE3 port.
Remote4: Make the settings for the REMOTE4 port.
3 Using any of the following methods, select the Aux bus.
•Press directly on the list in the status area.
•Press the arrow keys to scroll the reverse video cursor.
•Turn the knob to make the setting.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | No | Aux bus selection | 0 to 48 a) |
a)0: EDIT PVW
1 to 48: Aux1 to Aux48
258 Setup Relating to Switcher Processor