• Turn the knob to make the selection.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
3 | Command | Utility command selection | 1 ... |
|
|
|
|
When Shotbox Recall is selected: Turn the knob to select the shotbox register you want to assign.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
3 | Shotbox | Shotbox register selection | 1 to 99 |
|
|
|
|
5 Press [Action Set].
This assigns the selected action, which is reflected in the status area. In the utility/shotbox control block, the assigned button lights orange. If a shotbox register was assigned, the register name appears.
To cancel an assignment
After selecting the relevant button, press [Clear].
Assigning a menu shortcut to a memory recall button in the utility/shotbox control block
Use the following procedure.
1 Referring to the procedure up to step 3 in the previous item, select [Menu Shortcut].
The memory recall buttons in the utility/shotbox control block flash orange.
2 Using any of the following methods, display the menu to which you want to make a shortcut.
•In the menu control block, press the relevant top menu selection button, then select VF and HF.
•Press the menu page number button in the upper left corner of the menu screen, then enter a menu number from the numeric keypad window.
•Press a particular control panel button twice in rapid succession.
3 In the utility/shotbox control block, select the bank, and press the button to which you want to assign the shortcut.
The menu screen goes back to the Prefs/Utility>Utility Module Assign menu, and the selection is reflected in the status area.
The buttons in the utility/shotbox control block stop flashing, and the button to which the menu shortcut is assigned lights orange.
Setup Engineering 16 Chapter
Setup Relating to Operations From the Control Panel | 221 |
|
|