Setup Engineering 16 Chapter

Selecting the state at start-up

Use the following procedure.

1 In the status area of the System>Start Up menu, select the device to which the settings are to apply.

2 In the <Start Up Mode> group, select one of the following modes.

Resume: When this is on, Resume mode is enabled.

Custom: When this is on, Custom mode is enabled.

For information about Resume mode and Custom mode, see “System Setup” in Chapter 1 (Volume 1).

Note

The Resume mode is only valid when a switcher or control panel is selected for the setting. In this case, the initial status of the control panel applies only to the key bus delegation button settings.

3 When Custom mode is selected, in each of the <Setup> group and <Initial Status> group, select one of the following.

User: When this is on, user-defined settings are used for the Setup or Initial Status settings. For the method of saving the user-defined settings, see the next item.

Factory: When this is on, factory default settings are used for the Setup or Initial Status settings.

4 To confirm the settings, press [Execute]. If you want to cancel the setting changes without saving them, press [Clear].

When [Execute] is pressed, a confirmation message appears.

5 Select [Yes].

The start-up state settings are saved.

Saving user-defined settings

To save the Setup settings

Use the following procedure.

1 After selecting the devices the settings apply to, in the System>Start Up menu, press [Setup Define].

A confirmation message appears.

200 Setup for the Whole System