Note
Edges cannot be softened when the Crop effect is disabled.
Beveled Edge Settings
This effect applies a beveled frame appearance to an image.
For sample images, see “DME Special Effects” in Chapter 1 (Volume 1).
Applying a beveled edge
Use the following procedure.
1 In the DME menu, select VF1 ‘Edge’ and HF2 ‘Beveled Edge.’
The Beveled Edge menu appears.
2 Press [Beveled Edge], turning it on.
This enables the beveled edge, and you can now use the knobs to adjust the edge width parameters.
Note
When the border is enabled, the edge soft function (see page 26) is not available.
3 Set the parameters.
The valid ranges of the parameter values depend on the aspect ratio (4:3/ 16:9) selected in the system, as follows.
•4:3 mode
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | H | Simultaneously adjust width of left | 0.00 to 4.00 |
|
| and right edges |
|
|
|
|
|
2 | V | Simultaneously adjust width of top | 0.00 to 3.00 |
|
| and bottom edges |
|
|
|
|
|
3 | All | Simultaneously adjust width of all | Value of H shown |
|
| four edges |
|
|
|
|
|
• 16:9 mode
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | H | Simultaneously adjust width of left | 0.00 to 4.00 |
|
| and right edges |
|
|
|
|
|
Operations DME 11 Chapter
DME Special Effect Operations 27