Operations DME 11 Chapter
Adding a border
Use the following procedure.
1 In the DME menu, select VF1 ‘Edge’ and HF1 ‘Border/Crop.’
The Border/Crop menu appears.
2 Press [Border], turning it on.
The Border effect is enabled. You can adjust the border width parameters with the knobs.
Note
Once the Border effect is enabled, you cannot use the Edge Soft effect (see page 26).
3 Set the parameters.
Parameter limits vary as shown below, depending on the aspect ratio (4:3 or 16:9) selected in the system.
• 4:3 mode
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | H | Border width on left and right | Left value shown |
|
| sides |
|
|
|
|
|
2 | V | Border width on top and bottom | Top value shown |
|
| sides |
|
|
|
|
|
3 | All | Border width on all sides | Left value shown |
|
|
|
|
5 | Density | Border density | 0.00 to 100.00 |
|
|
|
|
6 | Top | Border width on top side | −6.00 to +6.00 |
|
|
|
|
7 | Left | Border width on left side | −8.00 to +8.00 |
|
|
|
|
8 | Right | Border width on right side | −8.00 to +8.00 |
|
|
|
|
9 | Bottom | Border width on bottom side | −6.00 to +6.00 |
|
|
|
|
10 | Density | Border density | 0.00 to 100.00 |
|
|
|
|
• 16:9 mode |
|
| |
|
|
|
|
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | H | Border width on left and right | Left value shown |
|
| sides |
|
|
|
|
|
2 | V | Border width on top and bottom | Top value shown |
|
| sides |
|
|
|
|
|
3 | All | Border width on all sides | Left value shown |
|
|
|
|
24 DME Special Effect Operations