Linking switcher bus and routing switcher destination
To provide links between the switcher bus and routing switcher destination, make the following settings as required.
Matrix selection: Select the target of link setting from the eight matrices (1 to 8).
Matrix position definition: Set the start address and level for the source and destination on the
Link table setting: Link a switcher
Link bus setting: Link a switcher bus address and routing switcher destination.
To select a matrix number
Use the following procedure.
1 In the Panel>Config menu, press [External Bus Link].
The External Bus Link menu appears.
The status area shows the current link status.
2 Turn the knobs to select the matrix.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
1 | Link No | Link number | 1 to 64 |
|
|
|
|
2 | Link Matrix | Matrix number | 1 to 8 |
|
|
|
|
In the status area, the color of the selected part changes.
3 Press [Link Matrix Set].
This confirms the matrix selection and the selected part in the status area returns to the previous color.
To delete a link
With the link selected, press [Clear].
To define the position of a matrix
Specify where in the 1024 × 1024
For the matrix selected in the External Bus Link menu, use the following procedure.
1 In the Panel>Config>External Bus Link menu, press [Link Matrix Adjust].
The Link Matrix Adjust menu appears.
Setup Engineering 16 Chapter
Setup Relating to Operations From the Control Panel | 207 |
|
|