Setup Engineering 16 Chapter

6 Using any of the following methods, select the action to be set.

•Press directly on the list appearing in the status area.

•Press the arrow keys to scroll the reverse video cursor.

•Turn the knobs to make the setting.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

2

Action

Action selection

1 to ... a)

5

Reg No

Register number

1 to 4 b)

a)• Action list when the trigger type is other than “Status”

When Source is M/E-1, M/E-2, or M/E-3: Key1 SS ? Recall, Key2 SS ? Recall, Key3 SS ? Recall, Key4 SS ? Recall, No Action

When Source is P/P: DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK 4 SS ? Recall, No Action

When Source is Common: KF Run, No Action

•Action list when the trigger type is “Status”

When Source is M/E-1, M/E-2, or M/E-3: Key1 SS ? Recall, Key2 SS ? Recall, Key3 SS ? Recall, Key4 SS ? Recall

Key1 On, Key2 On, Key3 On, Key4 On, No Action

When Source is P/P: DSK1 SS ? Recall, DSK2 SS ? Recall, DSK3 SS ? Recall, DSK4 SS ? Recall

DSK1 On, DSK2 On, DSK3 On, DSK4 On, No Action When Source is Common: Error Make, Error Break, No Action

b) When knob 2 selection is “Key Snapshot”

7 Press [Action Set] to confirm the action selection.

The selected setting appears in the status area.

Test firing the trigger

To test fire the trigger, press [Test Fire].

This outputs a trigger from the selected output port. This is not output when the trigger type is “Status.”

Setting the control mode for P-BUS devices

In the <P-Bus Control> group of the Panel>Device Interface menu, select the mode.

Trigger: When a predetermined button is pressed, the action command assigned to that button is output, to control an external device.

Timeline: The external device is controlled as a keyframe effect controlled by the center control panel.

Making DCU serial port settings

You can assign buttons in the device control block (DEV1 to DEV12) to DCU serial ports, to operate the devices (disk recorder/VTR) connected to these ports. For a disk recorder, you can also set the sharing of file lists.

226 Setup Relating to Operations From the Control Panel