Executing an effect automatically
Use the following procedure.
1 Select the region in which you want to execute the effect, using the region selection buttons in the numeric keypad control block. (See step 2 (page 116) of “Recalling a register.”)
2 With the numeric keypad, enter the number of the register in which the effect you want to execute is saved, and press the [ENTER] button to confirm.
This recalls the effect saved in the register.
3 In the keyframe control block, press the [RUN] button.
The [RUN] button lights amber and the effect is executed automatically.
Moving to the first keyframe of the effect
To move to the first keyframe of the effect, press the [REWIND] button.
Moving to the last keyframe of the effect
To move to the last keyframe of the effect, press the [FF] button.
Run Mode Setting
You can set the run mode in which an effect is executed when you press the [RUN] button.
Specifying the effect execution direction
To specify the effect execution direction, press the [NORM] button or the [REV] button, turning it on. When you press one, turning it on, the other automatically goes off.
To execute the effect so as to obtain the effects of the [NORM] and [REV] buttons alternately, press the [NORM/REV] button, turning it on.
When the [NORM] button is lit: The effect is executed in the direction from the first keyframe to the last keyframe.
When the [REV] button is lit: The effect is executed in the direction from the last keyframe to the first keyframe.
When the [NORM/REV] button is lit: Each time the effect is executed, the direction reverses.
Effects Keyframe 13 Chapter
Executing Effects 141