2 Press [V Blank Mask].
3 Adjust the parameter.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
2 | Mask End | Final value for vertical blanking | See note a) below |
|
| interval |
|
|
|
|
|
a)Depending on the signal format, the adjustment range varies as follows.
•480i: 10 to 19
•576i: 6 to 22
To return the values to their defaults, press [Default].
4 To enable the through mode, press [Through Mode], setting it to Enable. The through mode can be applied to the following outputs.
•Aux 1 to 48
•Program outputs of the M/E and PGM/PST rows
•Clean outputs of the M/E and PGM/PST rows
Making safe title settings
Use the following procedure.
1 In the Switcher>Output menu, press [Safe Title].
The Safe Title menu appears.
The status area shows the output ports and the assigned signals, with the box 1, box 2, and cross states.
2 To enable the safe title on/off setting made in the Misc menu, press [Safe Title], turning it on.
3 Carry out either of the following operations.
To display a box: Press [Box1] or [Box2], turning it on.
In this case, carry out the following steps 4 and 5.
To display a cross: Press [Cross], turning it on.
4 When you selected [Box1] or [Box2] in step 3, adjust the following parameters.
Knob | Parameter | Adjustment | Setting values |
|
|
|
|
2 | Box Size | Box size | 50.00 to 100.00 |
|
|
|
|
3 | Luminance | Display brightness | 0.00 to 100.00 a) |
Setup Engineering 16 Chapter
Setup Relating to Switcher Processor | 243 |
|
|