Dell NX046 manual Installing Memory, 190

1Follow the procedures in "Before You Begin" on page 151.

2Remove the computer cover (see "Removing the Computer Cover" on page 153).

3Rotate the hard-drive carrier out of the computer (see "Rotating the Hard- Drive Carrier Back into the Computer" on page 159).

CAUTION: Fully-buffered memory modules may become very hot during normal operation. Ensure that memory modules have had sufficient time to cool before you touch them.

4Press out the securing clip at each end of the memory module connector.

1

2

1 memory module 2 securing clip (2)

5Grasp the module and pull up to lift the memory module from the memory riser card.

If a module is difficult to remove, gently ease it back and forth to remove it from the connector.

6Rotate the hard-drive carrier back into place (see "Rotating the Hard-Drive Carrier Back into the Computer" on page 159).

7Replace the computer cover (see "Replacing the Computer Cover" on page 161).

Installing Memory

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

190

Adding and Replacing Parts