NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.
17Connect the computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
18If the drive you just installed is the primary drive, insert bootable media into drive A.
19Turn on the computer.
20Enter the system setup program (see "System Setup" on page 89) and update the appropriate Drive option.
21Exit system setup, and reboot the computer.
22Partition and logically format your drive before you proceed to the next step.
23See the documentation for your operating system for instructions.
Drive Panels
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
Removing the Drive Panel
1Follow the procedures in "Before You Begin" on page 151.
2Remove the front panel (see "Removing the Front Panel" on page 155).
3Grasp the sliding plate lever and push it towards the base of the computer until the drive panel snaps open.
Adding and Replacing Parts
