1
2
1 | drive retention insert | 2 | floppy drive |
7Remove the floppy drive from the FlexBay.
8If you are not installing another drive in the FlexBay, and metal shields are present in your computer (see "About the Metal Shields Present in Some Drive Configurations" on page 207), install the vented metal insert over the FlexBay and the empty space beneath it:
a Holding the metal insert at an angle, insert its two upper screws into the slot that runs along the inside of the FlexBay.
b Rotate the bottom of the vented metal insert down and insert its two bottom screws into the slot in the open area beneath the FlexBay.
c Push the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface.
Then, install a
248
Adding and Replacing Parts
