aInsert the metal insert’s two upper screws and its two lower screws into the corresponding slots inside the FlexBay.

bPush the vented metal insert until it clicks into place and its metal tabs rest flush against the chassis surface.

13Reinstall the drive panel (see "Replacing the Drive Panel" on page 237).

14Ensure that all connectors are properly cabled and firmly seated.

15Replace the computer cover (see "Replacing the Computer Cover" on page 161).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

16Connect the computer and devices to electrical outlets, and turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

17If the drive you just installed is the primary drive, insert bootable media into drive A.

18Turn on the computer.

19Enter the system setup program (see "System Setup" on page 89) and update the appropriate Drive option.

20Exit the system setup program, and reboot the computer.

21Partition and logically format your drive before you proceed to the next step.

See the documentation for your operating system for instructions.

22Test the hard drive. See "Dell Diagnostics" on page 136 for instructions.

23If the drive you just installed is the primary drive, install your operating system on the hard drive.

Removing an Optional SATA Third Hard Drive (Desktop Computer Only)

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

1Follow the procedures in "Before You Begin" on page 151.

Adding and Replacing Parts

225

Page 225
Image 225
Dell NX046 manual 225