1

2

3

4

1

P3 power connector

2

SATA data cable

3

hard-drive power cable

4

hard drive

NOTICE: If only one hard drive is to be installed, it should be connected to the SATA0 connector on the system board.

12Ensure that all connectors are properly cabled and firmly seated.

13Rotate the hard-drive carrier back into place (see "Rotating the Hard-Drive Carrier Back into the Computer" on page 159).

14Replace the computer cover (see "Replacing the Computer Cover" on page 161).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

15Connect the computer and devices to electrical outlets, and turn them on.

See the documentation that came with the drive for instructions on installing any software required for drive operation.

Adding and Replacing Parts

217

Page 217
Image 217
Dell NX046 manual 217