Hach user manual Connect probes to the sc1000 controller, Connect the probe data cable

Installation

3.8 Connect probes to the sc1000 controller

All sc series probes can be used on the sc1000 controller.

Important Note: Plan the route for the probe cable and lay the data and power cables so that they do not cause a trip hazard and the cables do not have any sharp bends.

For details on the installation and operation of the probe, refer to the appropriate probe manual.

3.8.1Connect the probe data cable

1.Unscrew the protective cover on the controller socket (Figure 33). Retain the protective cover. When you remove the probe, re-fit the protective cover.

2.Align the connector plug with the socket, pay attention to the orientation of the connector lugs.

3.Hand-tighten the union nut.

Note: Keep the middle connection of the probe module free. Use the free port to connect the display module to each probe module in a network.

Figure 33 Removing the protective cover

1sc probe connection

2Protective cover

43