466 CIS ANI Digits Manipulation and Gateways Enhancements
Prompt Response Description
•If ANIC=YES for the outgoing CIS route where the call
takes place, then the components of the ANI message are
retrieved from the ANI entry in Customer Data Block, if
configured.
•If the given ANI Entry is not configured, or if ANIC=NO for
the outgoing CIS route where the call takes place, then the
old mechanism is used for building the ANI message.
LD 27 - Configure the CAC for CIS and MFC signaling for BRI sets.
Prompt Response Description
REQ NEW
CHG Add new data.
Change existing data.
TYPE DSL Digital Subscriber Loop.
DSL l s c dsl
c u dsl
Digital Subscriber Loop
For Large Systems
For Small Systems
... ...
CAC_CIS 0-(3)-9 CIS ANI category code.
CAC_MFC (0)-10 MFC CNI category code.

CIS Gateways Enhancements feature implementation

This section contains the overlay procedures required to configure the CIS

Gateways Enhancements feature.

Feature implementation for R2MFC route

In case of gateway R2MFC/CIS it must be noticed that to be tandemed CNI

must be received on R2MFC route before outgoing CIS trunk is seized. This

is possible using an up-front CNI request. Up-front CNI request is defined

on R2MFC route by giving a non zero value to prompt NCNI. Configure the

ANI table entry and CAC conversion table for Incoming CIS DTI2 route

using LD 16.

LD 15 - Configure the ANI route table and CAC conversion table.
Prompt Response Description
REQ: NEW
CHG Add new data.
Change existing data.
REQ = NEW, default table R_SIZE (0) is created.
REQ = NEW, default table CACC(0) is created.
REQ = NEW, R_SIZE defaults to number of ANI entries.
for incoming route created during conversion.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008
Copyright © 1994–2008, Nortel Networks
.