550 Collect Call Blocking
Prompt Response Description
M911_ANI NO M911 route. Must be set to NO to enable CCB.
...
ISDN NO ISDN route. Must be set to NO to enable CCB.
...
ICOG IAO ICT OGT Incoming and outgoing, incoming, or outgoing. Must be
either IAO or ICT to enable CCB.
Must be either IAO or OGT to get the CCBA prompt for
outgoing calls.
...
CNTL (NO) YES Change to controls or to timers.
...
CCB (NO) YES Collect Call Blocking enabled or disabled on incoming
route. CCB package 290 is required. Enter YES to obtain
CCB timer prompts.
CCB1 512-(1536)-4992 Collect Call Blocking delay timer 1 in milliseconds. Input
rounded to the next multiple of 128 milliseconds.
CCB2 500-(1520)-2550 Collect Call Blocking delay timer 2 in milliseconds. Input
rounded to the next multiple of 10 milliseconds. If any CCB
route members (trunks) are using firmware timing (FWTM
= YES in LD 14), changes to the CCB2 timer value will not
take effect until the new timer value is downloaded to the
card. This can be done by enabling the card or initializing
the switch.
CCBA (NO) YES Collect Call Blocking allowed or denied for outgoing route.
LD 14 - Setup the firmware timing for XFCOT and EXUT cards.
Prompt Response Description
REQ NEW
CHG Add.
Change.
TYPE DID COT FEX
WAT Trunk Type.
TN Terminal number
l s c u Format for Large System and CS 1000E system,
where l = loop, s = shelf, c = card, u = unit.
cu Format for Small System and Media Gateway 1000B where
c = card and u = unit.
XTRK EXUT
XCOT Type of card.
Nortel Communication Server 1000
Features and Services Fundamentals — Book 2 of 6 (C)
NN43001-106 02.04 Standard
Release 5.5 9 May 2008
Copyright © 1994–2008, Nortel Networks
.