Common display prompts and error messages 139
Priority> 221
BLOCK
Release a call
Use line pool?
YES NO
Hold or release
Release calls
Line in use
No button free
Make calls first
No free lines
No line selected
In use:221
You are receiving a priority call. If you are on another call, tell the person you are speaking to that you are about to put the call on hold. Press the flashing line indicator of the priority call or wait until the call connects automatically (in eight seconds). The priority call goes through after you hear the next beep. Your active call is on Exclusive Hold. It reconnects automatically when the priority call ends (unless you transfer the priority call, in which case you must press the line button of your original call to reconnect). Use DND (≤°fi) or press BLOCK to reject a priority call.
You have no free line available to receive a call. Release one of your current calls and try again to answer the incoming call.
You received a Ring Again offer for a line pool. Press the flashing internal line button or YES to use the line pool. On the T7100 telephone, lift the handset. Otherwise, press NO or wait 30 seconds for the Ring Again offer to expire.
While on a call, you must either release the call or put the call on hold before you can program a feature button.
You tried to use a feature while you were on a call or had calls on hold. Release the call or calls, before using the feature.
The line is in use. Make the call using normal methods or wait until a line is free.
You tried to make, receive or pick up a call when no line button was available. Some features require you to have a button free. Releasing calls can free up line buttons.
The feature you tried to use requires you to be on an active call at your telephone. This prompt also appears when information about a call is cleared by a system reset.
All the lines or line pools available to the telephone are in use. This prompt also appears when you try to dial an external number or use a feature that conflicts with the lines, line pools or prime line used by the telephone. Your installer must correct this situation.
The telephone is set up to dial an external number on a prime line but the telephone does not have a prime line. Your installer must correct this situation.
You tried to program redirection while the feature is in use. Only one person can program line redirection at a time.
Telephone Features Programming Guide
