Omega RD100B manual Setting the Alarm, Frequently Used Setup Operations Setting Mode

5.2 Setting the Alarm

The alarm is set for each channel.

If you change the input range, set the alarm again.

Procedure

1.Hold down the MENU key for 3 seconds to enter Setting mode.

2.Press the key or SHIFT + key to select Alarm and then press the key.

3.Set each item and press the key.

Use the key or SHIFT + key to select values.

For the procedure on how to enter values or characters, see section 4.2.

If you press the ESC key in the middle of the operation, the settings entered up to then are cancelled, and the display returns to a higher level menu.

4.When the Setting complete screen appears, do either of the following: Press the key to set other channels.

If you are done, press the ESC key.

5.Hold down the MENU key for 3 seconds to return to Operation mode.

Set=Alarm

CH=	01		-01							Set the channel range.
First channel							Last channel			Select the level number between 1 and 4.
Level=					1
										Select On to set the alarm.
Alarm=				Off
										When set to On, the settings below can
										be entered.
										Select the alarm type.
Type=		H
										Select the value used to turn On the alarm.
Value=								1.000
										Turn relay On when outputting alarms on
Relay=						Off
										the relay. This setting is valid only on
										models with the /A1, /A2, or /A3 option.
										Specify the alarm relay No.
Relay_No.=									I01
										The new setting takes effect.
01-01 CH/level 1

ESC/? Setting complete

5

Frequently Used Setup Operations (Setting Mode)

5-9