Omega RD100B manual Installing/Replacing the Ribbon Cassette Dot Model, Holder tab

3.4Installing/Replacing the Ribbon Cassette (Dot Model)

CAUTION

•Improper cassette insertion may cause the color to change or damage the ribbon.

•Do not apply upward force to the printer carriage. If you do, the carriage position may be offset, and the recorder may not print correctly.

1.Open the door.

If recording is in progress, press the RCD key to stop the recording.

2.Press theFUNC key.

3.Press the ( DISP ) key several times to display R. exchange.

Func=R. exchange

4.Press the ( CH UP ) key.

The printer carriage moves near the center position, and R. exchange = End is displayed.

5.Open the display and key panel section.

You can open the display and key panel section by holding the tab at the lower left and pulling it toward you.

Note

If the recorder is OFF, pinch the printer carriage and move it near the center position.

Printer carriage

6.Remove the ribbon cassette.

Pull the left-hand part of the ribbon cassette so that the cassette holder tab disengages, and pull the ribbon cassette out from the recorder case.

Holder tab

3

Names of

Parts and

Run Operations

3-9