3.8 Printing the Recorder Settings

This section explains the procedure for printing the recorder settings. There are two sets of settings that can be printed: List and Setup.

List: Prints the settings of Setting mode (input range for each channel, etc.)

Setup: Prints the settings of Basic Setting mode

Note

The printout takes several minutes to tens of minutes to complete.

When this printout is executed, trend recording is suspended. However, the recorder continues the measurement and alarm detection (in the background).

When the printout is complete, trend recording resumes.

If an alarm occurs during the printout, the alarm is printed after the trend recording resumes.

Procedure

Starting the List Printout

1.Press the FUNC key.

2.Press the key to select Print out and then press the key.

3.Press the key to display List Start and then press the key. The List printout starts. The screen returns to the data display screen.

Print=List Start

Aborting the List Printout

1.Press the FUNC key.

2.Press the key to select Print out and then press the key.

3.Press the key to display List Stop and then press the key. The List printout stops. The screen returns to the data display screen.

Print=List Stop

Starting the Setup Printout

1.Press the FUNC key.

2.Press the key to select Print out and then press the key.

3.Press the key to display Setup Start and then press the key. The Setup printout starts. The screen returns to the data display screen.

Print=Setup Start

Aborting the Setup Printout

1.Press the FUNC key.

2.Press the key to select Print out and then press the key.

3.Press the key to display Setup Stop and then press the key. The Setup printout stops. The screen returns to the data display screen.

Print=Setup Stop

* When the key or key is pressed while holding down the SHIFT key, the operation is reversed as when the respective key is pressed by itself.

3-14

Page 72
Image 72
Omega RD100B manual Printing the Recorder Settings, Starting the List Printout, Aborting the List Printout