Omega RD100B manual Changing the Auxiliary Alarm Function, Changing the Settings

Chapter 7 Setup Operations for Changing/Adding Functions (Basic Setting Mode)

7.1 Changing the Auxiliary Alarm Function

This section explains the details of setting the alarm system items listed below.

•Diagnosis output using the alarm output relay (I01)

•Reflash alarm operation of the alarm output relay (I01 to I03)

•AND/OR operation of alarm output relays

•Energized/De-energized operation of alarm output relays when alarms occur

•Hold/Non-hold operation of alarm output relays

•Hold/Non-hold operation of alarm indications

•The interval of the rate-of-change alarm

•Alarm hysteresis

Basic Setting mode cannot be entered when recording is in progress or when computation is in progress on models with the computation function (/M1 option).

Procedure

Changing the Settings

1.Hold down the MENU key for 3 seconds to enter Setting mode.

2.Hold down the and keys simultaneously for 3 seconds to enter Basic Setting mode.

3.Press the key with Alarm shown on the screen.

4.Set each item and press the key.

Use the key or SHIFT + key to select values.

For the procedure on how to enter values or characters, see section 4.2.

If you press the ESC key in the middle of the operation, the settings entered up to then are cancelled, and the display returns to a higher level menu.

5.When the Setting complete screen appears, do either of the following: To correct the setting, press the key.

If you are done, press the ESC key.

7

Setup Operations

for Changing/Adding Functions (Basic Setting Mode)

7-1