
Installing Options and Accessories
4.Install wiring from the Powerware Hot Sync CAN Bridge Card in accordance with the instructions listed below:
Parallel system wiring (see paragraph 6.2)
RMP II wiring (see paragraph 6.3)
RIM II (see paragraph 6.4)
SCM II (see paragraph 6.5)
6.2Installing Parallel System Control Wiring
NOTE When installing external wiring to the
NOTE When installing interface wiring for the parallel system pull chain, conduit must be installed between UPMs.
To install parallel system control wiring, perform the following procedure:
1.Verify the UPS system is turned off and all power sources are removed. See Chapter 10, “UPS Operating Instructions,” for shutdown instructions.
2.Perform the procedure listed in paragraph 6.1.
3.If not already removed, remove the doors. Remove the retaining screws located inside each door at the top and bottom hinge pivot points, then lift the door off. Retain the hardware for later use.
4.Remove the screws securing the control panel door and swing the door open. Retain the hardware for later use.
5.Remove the screws securing the top internal safety shield panel. Remove the panel to gain access to the TB1 and TB2 terminal blocks,
page
6.If installing interface wiring from the bottom of the cabinet, proceed to Step 7; otherwise, proceed to Step 8.
7.Remove the screws securing the bottom internal safety shield panel and remove the panel to gain access to the bottom conduit landing plate.
8.Remove the
9.Reinstall the conduit landing plate and install the conduit.
10.Install CAN wiring between UPMs. See Drawing
EATON Powerware® 9390 UPS |