Chapter 3: Setup
In order to use this logical drive to read and write data, you must partition and format it using the Host PC’s operating system.
Assign a SCSI Target ID
The term Target ID refers to the SCSI address of the two channels on the RAID subsystem. A SCSI bus has an Initiator, such as the SCSI card inside the Host PC, and at least one Target, such as the Controller and Logical Drives inside the RAID subsystem. Each target must have its own address or Target ID number.
Target IDs can be divided into Logical Unit Numbers (LUNs) to extend the number of available addresses. The default TID settings for both SCSI channels is 0. This setting is adequate for most WebPAM and RAID subsystem configurations. If an address conflict occurs, you might have to change the TID setting.
You must have Creation Rights to access this function.
To access SCSI Target ID settings:
1.Click on the Subsystem 
icon in Tree View.
2.Click on the VTrak 
icon.
3.Click on the SCSI Management 
icon.
4.Click on the TID Settings tab.
To make settings:
1.Select the SCSI Target IDs you want to use on SCSI Channel 1.
2.Select the SCSI Target IDs you want to use on SCSI Channel 2.
3.Click the Submit button when you are done.
55
