65
Chapter 4: Management with WebPAM PRO
This chapter describes using WebPAM to monitor and manage your RAID
system. This chapter is divided into sections for major WebPAM components as
shown above.

VTrak Status Indicators

Even though WebPAM PRO offers comprehensive monitoring of VTrak, the LED
indicators on the VTrak unit provide important status information.
When the power is switched on, the LEDs on the front of the VTrak will light up.
Figure 1. VTrak 15110 Front Panel LEDs
When boot-up is finished and the VTrak is functioning normally:
• Controller LED blinks green once per second for five seconds, goes dark for
five seconds, then blinks green once per second for five seconds again.
• Power, FRU and Disk Array LEDs display green continuously.
• SCSI LEDs flash green if there is activity on that channel.
See the table below.
• VTrak Status Indicators (below)
• Drive Status Indicators (page66)
• Audible Alarm (page67)
• Log-in/Log-out (page68)
• Subsystem Management (page71)
• User Management (page77)
• Software Management (page87)
• Subsystem Management (page92)
• VTrak Management (page95)
• SCSI Management (page97)
• Network Management (page99)
• Service Management (page100)
• Controllers (page102)
• Enclosures (page104)
• Disk Arrays (page 110)
• Spare Drives (page127)
• Logical Drive Summary (page130)
Power FRU
Status Disk Array
Status SCSI-1
Activity SCSI-2
Activity Controller
Heartbeat