Samsung DCS-408I manual MMC 723 System KEY Programming, Type of SET, DCS/CII/816

DCS	MMC PROGRAMS
COMBINED PROGRAMMING MANUAL	NOVEMBER 2001

MMC: 723 SYSTEM KEY PROGRAMMING

DCS

3

CI

3

CII

3

816

3

408i

3

408

3

This MMC is similar to MMC 722, Station Key Programming. The difference is that MMC 723 pro- grams keys for all stations rather than individual stations.

All systems are provided with default functions for some keys to provide basic operation. For example, keys 1 and 2 are set as CALL keys by default because it is recommended that these keys should always function as CALL keys (but see Note, below). Other keys can be programmed as described here. You can use the UP and DOWN keys to scroll through the selectable functions when programming keys (see table at the end of this MMC).

Functions can also be entered via the dial keypad. For example, to assign the OHVA function, key number 6 can be pressed three times. If the BOSS function is required, press 2 twice for the first letter B, and then use the UP or DOWN key to change the selection from BARGE to BOSS.

Note: Default key functions are different for 408/408i systems compared to all other systems. For example, keys 1 and 2 are not set as CALL keys by default as these are not required.

Programming in MMC 723 is also done on the basis of keyset type (12-button, 24-button, etc).

TYPE OF SET

Dial	DCS/CII/816	408/408i
0	24-BTN	24-BTN
1	12-BTN	24-BTN EURO
2	6-BTN	12-BTN
3	–	6-BTN
4	48-BTN AOMS	28-BTN
5	–	18-BTN
6	28-BTN	8-BTN
7	18-BTN	24B SIMPLE
8	8-BTN

PROGRAM KEYS
UP & DOWN	Used to scroll through options
KEYPAD	Used to enter selections
SOFT KEYS	Move cursor left and right
SPEAKER	Used to store data and advance to next MMC
HOLD	Used to clear previous entry

ACTION

1.Open programming and select 723 Display shows

OR

For 408/408i systems, display shows

(but programming procedure is the same as follows)

DISPLAY

TYPE:24 BTN SETS 01:CALL1→

OR

TYPE:24 BTN SETS 01:DT71 →

MMC 723 (Page 1 of 3)