Samsung DCS-408I manual MMC 725 Smdr Options

DCS	MMC PROGRAMS
COMBINED PROGRAMMING MANUAL	NOVEMBER 2001

MMC: 725 SMDR OPTIONS

DCS

3

CI

3

CII

3

816

3

408i

3

408

3

Allows the system administrator to select the information to be printed on the SMDR report. The following options may be selected. All have YES/NO options (YES=print) except where a new value or directory name is required.

00	PAGE HEADER	Determines whether a page header prints at the top of each
		page. This would normally be turned off if SMDR is being sent to
		a call accounting machine.
01	LINE PER PAGE	Selects the length of each page to determine when to print the
		SMDR header. The number of lines is in the range 01–99.
02	INCOMING CALL	Determines whether incoming calls print on SMDR.
03	OUTGOING CALL	Determines whether outgoing calls print on SMDR.
04	AUTHORISE CODE	Determines whether authorisation codes print on SMDR.
05	SMDR START TIME	Determines whether valid calls will include the minimum call time
		in total call duration (set in MMC 501).
06	IN/OUT GROUP	Allows a message, IN GROUP or OUT GROUP, to be printed in
		the Digits Dialled column each time a station enters or leaves a
		group.
07	DND CALL	Allows a message, DND ON or DND OFF, to be printed in the
		Digits Dialled column each time a station enters or leaves DND.
08	WAKE-UP CALL	Determines whether stations receiving an alarm reminder call
		print on SMDR.
09	DIRECTORY NAME	Allows the system administrator to enter a 16-character name
		which will appear on the SMDR header.
10	CALLER ID DATA	Can be selected to print CLIP data received from the C.O. on
		incoming ISDN calls. This option requires the use of a 132-
		column printer or an 80-column printer set for condensed print.
		(Not available on 408 systems.)
11	ABANDON CALL	If this option is set to YES, unanswered calls will print on SMDR.
		(Not available on 408 systems.)
13	NO. OF DIAL MASK	Number of dialled digits not to be printed (00–18)
14	DID NUM/NAME	Determines whether DDI number and name print on SMDR. (Not
		available on 408 systems.)

The DIRECTORY NAME that appears on the SMDR header is written using the keypad. Pressing a key selects a character and moves the cursor to the next position. For example, if the directory name is “SAM SMITH,” press the number “7” four times to get the letter “S.” Now press the number “2” once to get the letter “A.” Continue selecting characters from the keypad to complete the name. Press the programmable ”A” key to toggle between upper and lower case text.

Tip: When the character you want is on the same key as the previous character you typed in, press the UP key to move the cursor to the right, and enter the new character.

MMC 725 (Page 1 of 3)